/* * This file is part of the canuart project. * Copyright 2022 Edward V. Emelianov . * * This program is free software: you can redistribute it and/or modify * it under the terms of the GNU General Public License as published by * the Free Software Foundation, either version 3 of the License, or * (at your option) any later version. * * This program is distributed in the hope that it will be useful, * but WITHOUT ANY WARRANTY; without even the implied warranty of * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the * GNU General Public License for more details. * * You should have received a copy of the GNU General Public License * along with this program. If not, see . */ #include "hardware.h" uint8_t ledsON = 0; void gpio_setup(void){ RCC->APB2ENR |= RCC_APB2ENR_IOPAEN | RCC_APB2ENR_IOPBEN | RCC_APB2ENR_IOPCEN | RCC_APB2ENR_AFIOEN; LED_off(LED0); LED_off(LED1); // Set leds (PA0/PA4) as opendrain output GPIOA->CRL = CRL(0, CNF_ODOUTPUT|MODE_SLOW) | CRL(4, CNF_ODOUTPUT|MODE_SLOW); #ifdef BLUEPILL GPIOC->CRH = CRH(13, CNF_PPOUTPUT|MODE_SLOW); #endif } void iwdg_setup(){ uint32_t tmout = 16000000; /* Enable the peripheral clock RTC */ /* (1) Enable the LSI (40kHz) */ /* (2) Wait while it is not ready */ RCC->CSR |= RCC_CSR_LSION; /* (1) */ while((RCC->CSR & RCC_CSR_LSIRDY) != RCC_CSR_LSIRDY){if(--tmout == 0) break;} /* (2) */ /* Configure IWDG */ /* (1) Activate IWDG (not needed if done in option bytes) */ /* (2) Enable write access to IWDG registers */ /* (3) Set prescaler by 64 (1.6ms for each tick) */ /* (4) Set reload value to have a rollover each 2s */ /* (5) Check if flags are reset */ /* (6) Refresh counter */ IWDG->KR = IWDG_START; /* (1) */ IWDG->KR = IWDG_WRITE_ACCESS; /* (2) */ IWDG->PR = IWDG_PR_PR_1; /* (3) */ IWDG->RLR = 1250; /* (4) */ tmout = 16000000; while(IWDG->SR){if(--tmout == 0) break;} /* (5) */ IWDG->KR = IWDG_REFRESH; /* (6) */ }